TITLE: SINGLE CLEANER?
Can the same cleaner be used to clean heads that use any type of ink?
NOT. People&Technology markets two types of cleaner, depending on the graphic resolution of the head.
The reference U-1012 is indicated for heads that have up to a graphic resolution of 400 DPI.
The reference U-0312 is indicated for heads that have more than 400 DPI of graphic resolution.
In case of doubt, it is recommended to use the reference U-0312.
ATTENTION: To clean heads using water-based inks, you must first make a transition with a special liquid and then they can be cleaned using the cleaners indicated above.
Ask our technical service for the reference of this product, since it depends on the ink used by the printhead.
ADD RELATED QUESTION
TITLE: RE-USE
Is it possible to process the cleaner used during head cleaning, so that it can be used again?
NOT. During its use in the cleaning of the heads, the cleaner gradually loses its cleaning properties, making it non-recoverable.
In addition, for informational purposes only, the cost of cleaning the cleaner in a professional and efficient manner, today exceeds the cost of the new cleaner.
ADD RELATED QUESTION
TITLE: STORAGE
What is the correct way to store the cleaner?
The best way is to store it in the same room where the CLEANJECTOR is located.
We remind you that the CLEANJECTOR machine must be installed in a room with a controlled temperature between 20ºC and 28ºC (degrees Celsius).
This temperature is also ideal for storing the cleaner.
It is most correct for the cleaner to remain inside the cardboard box until it is to be used, to prevent long exposure to light.
TITLE: EXPIRATION
Does the cleaner have an expiration date?
NOT. If the cleaner is properly stored, at the right temperature and protected from light, it can be stored for years before use.
ADD RELATED QUESTION
TITLE: MIXTURE
Can this cleaner be mixed with other types of detergents or water?
NOT
You should NEVER mix this cleaner with other products.
Firstly, because you do not know the type of chemical reaction that can occur and that could be harmful to health.
Secondly, because it could cause irreparable damage to the CLEANJECTOR machine.
Third, you can NEVER add water to the head cleaning process, as it will generally irreversibly damage the heads.
CLEANJECTOR is prepared to work with the cleaner produced by People & Technology. For the correct operation of the machine and the process.
Adding this cleaner with other products, apart from the damage described above, would produce changes in the density and viscosity of the product, which will cause the CLEANJECTOR to malfunction and could even cause the heads to break.
ADD RELATED QUESTION
TITLE: MASK
Is it necessary to use a mask while the cleaner is being used?
NOT. The use of cleaner U1012 is not harmful to people, nor does it give off any kind of vapor or odor, which forces the use of the mask as "Personal Protective Equipment" PPE.
For this reason, no pictogram appears in this product's labeling.
However, it is possible in some countries, the current legislation is more restrictive. In these cases, you must comply with the laws of your country.
ADD RELATED QUESTION
ADD NEW QUESTION